Configuring AAA for Administrative and Local Access 65

Displaying the AAA Configuration

To display your AAA configuration, type the following command:

23x0# show aaa

Default Values

authport=1812 acctport=1813 timeout=5 acct-timeout=5 retrans=3 deadtime=0 key=(null) author-pass=(null)

Radius Servers

 

 

Server

Addr

Ports T/o Tries Dead State

-------------------------------------------------------------------

r1192.168.253.1 1812 1813 5 3 0 UP

Server groups sg1: r1

set authentication console * local set authentication admin * local

set accounting admin Geetha stop-only local set accounting admin * start-stop local

user Geetha

Password = 1214253d1d19 (encrypted)

(For information about the fields in the output, see the Nortel WLAN Security Switch 2300 Software Command Reference.)

Saving the Configuration

You must save the configuration for all commands that you enter and want to use for future sessions. After you enter the administrator’s AAA configuration, type the following command to maintain these commands in WSS nonvolatile memory:

23x0# save config

success: configuration saved.

You can also specify a filename for the configuration—for example, configday. To do this, type the following command:

23x0# save config configday

Configuration saved to configday.

You must type the save config command to save all configuration changes since the last time you rebooted the WSS switch or saved the configuration. If the WSS switch is rebooted before you have saved the configuration, all changes are lost.

You can also type the load config command, which reloads the WSS switch to the last saved configuration or loads a particular configuration filename. (For more information, see “Managing Configuration Files” on page 526.)

Nortel WLAN Security Switch 2300 Series Configuration Guide

Page 65
Image 65
Nortel Networks 2300 manual Displaying the AAA Configuration, Saving the Configuration, 23x0# show aaa