Nortel Networks 2300 manual Configuring a Member, Set mobility-domain mode member seed-ip ip-addr

Configuring and Managing Mobility Domain Roaming 179

Configuring a Member

To configure a member WSS in the Mobility Domain, you enter the following command when logged in to the nonseed member WSS:

set mobility-domain mode member seed-ip ip-addr

This command configures the IP destination address that the member WSS uses when communicating with the seed WSS switch.

For example, the following command configures the current WSS as a member of the Mobility Domain whose seed is 192.168.253.6:

23x0# set mobility-domain mode member seed-ip 192.168.253.6

success: change accepted.

This command sets the WSS as a member of the Mobility Domain defined on the seed device at the identified address. If the WSS is currently part of another Mobility Domain or using another seed, this command overwrites that configura- tion. After you enter this command, the member WSS obtains a new list of members from its new seed’s IP address.

Nortel WLAN Security Switch 2300 Series Configuration Guide