Bloomfield 1088, 1086, 1082 Troubleshooting Suggestions, Symptom, Possible Cause, Suggested Remedy

TROUBLESHOOTING SUGGESTIONS
SYMPTOM	POSSIBLE CAUSE		SUGGESTED REMEDY
Water won’t heat	Brewer unplugged or circuit		Check power supply cord
	breaker tripped		Check / reset circuit breaker
	Temperature adjusted too low		Turn on and set for desired
	or set to OFF		temperature. See page 15
	Hi-Limit thermostat tripped		Allow to cool (1012, 1040 or
			1072), or allow to cool and
			reset hi-limit (1086, 1088)
	Damaged internal component or		Examine wiring & connectors,
	wiring		controller, power board and
			heating element
			Repair/replace as needed
Coffee level too high or low	Timer out of adjustment		Adjust controller. See page 16
Brew chamber overflows	Too many filter papers or wrong		Use one (1) genuine Bloomfield
	filter paper		filter per brew
	Brew chamber dispense hole		Thoroughly clean brew chamber
	plugged
Sprays water from brew head	Spray gasket improperly		Check/reinstall gasket on
	installed		INSIDE of brew head
No brew while faucet flows OK	Spray disk plugged		Clean spray disk
	Damaged internal component		Check keypad, controller, power
	or wiring		board & solenoid
			Repair, replace as needed	642
				75872
No brew plus no flow from hot	Water supply OFF		Turn water supply ON
water faucet				Owners
	Solenoid screen plugged		Clean solenoid screen
No flow from hot water faucet	Water line strainer (if used)		Clean strainer	ManualE.B
	Water filter (if used) plugged		Replace filter element
	plugged
				.C.
	Faucet valve turned OFF		Turn faucet valve ON
				Airpot
	Faucet plugged		Disassemble faucet, clean
				/Thermal
Poor coffee quality	Keep brewer, airpots and servers clean. Install a taste and odor
	filter in water supply, and replace cartridges regularly.
	Use a quality coffee with a consistent roast. Use proper grind and
	amount of coffee per brew.
		12