Bloomfield 1090, 1091, 1092 Troubleshooting Suggestions, Symptom, Possible Cause, Suggested Remedy

TROUBLESHOOTING SUGGESTIONS
	SYMPTOM	POSSIBLE CAUSE		SUGGESTED REMEDY
	Water won’t heat	Brewer unplugged or circuit		Check power supply cord
		breaker tripped		Check / reset circuit breaker
		Temperature adjusted too low		Turn on and set for desired
		or set to OFF		temperature. See page 15
		Hi-Limit thermostat tripped		Allow to cool. Reset hi-limit
		Damaged internal component or		Examine wiring & connectors,
		wiring		controller, power board and
				heating element
				Repair/replace as needed
	Coffee level too high or low	Timer out of adjustment		Adjust controller. See page 16
	Brew chamber overflows	Too many filter papers or wrong		Use one (1) genuine Bloomfield
		filter paper		filter per brew
		Brew chamber dispense hole		Thoroughly clean brew chamber
		plugged
	Sprays water from brew head	Spray gasket improperly		Check/reinstall gasket on
		installed		INSIDE of brew head
	No brew while faucet flows OK	Spray disk plugged		Clean spray disk
		Damaged internal component		Check keypad, controller, power
		or wiring		board & solenoid
				Repair, replace as needed
	No brew plus no flow from hot	Water supply OFF		Turn water supply ON
	water faucet
		Solenoid screen plugged		Clean solenoid screen
		Water line strainer (if used)		Clean strainer
		plugged
	No flow from hot water faucet	Water filter (if used) plugged		Replace filter element
		Faucet valve turned OFF		Turn faucet valve ON
		Faucet plugged		Disassemble faucet, clean
	Poor coffee quality		Keep brewer and decanters clean. Install a taste and odor filter in
			water supply, and replace cartridges regularly.
			Use a quality coffee with a consistent roast. Use proper grind and
			amount of coffee per brew.

12

645 75908 Owners Manual E.B.C. Dual Airpot/Thermal Brewer