INITIAL SET-UP: PORTABLE DISPENSERS
1.Turn POWER switch OFF.
Turn WATERLINE / PORTABLE switch to PORTABLE Turn HEATER switch OFF.
Turn COLD/HOT / HOT/HOT switch to HOT/HOT Turn DISPENSE / FLUSH switch to flush
2.Add water to tank.
NOTE: To avoid an overflow when the water bottle is installed, fill only until water touches the LOW WATER probe.
3.Fill water bottle (SUPPLIED BY OTHERS). Invert water bottle and insert in tank.
4.Connect unit to electrical power. Turn POWER switch ON. Turn the HEATER switch ON.
Place tank cover on water tank.
5.Place an empty container under the left dispensing nozzle. Press and hold left dispense key for several seconds. Discard all water generated. Repeat for center (9456 only) and right dispense nozzles.
6.Turn DISPENSE / FLUSH switch to DISPENSE.
7.Fill and install the PRODUCT HOPPERS (see page 10).
8.Close front door. Install the drip tray assembly. When water reaches serving temperature, dispenser is ready to use.
IMPORTANT:
The heating element will be damaged if it is energized without sufficient water. The element must be covered with water at all times it is in operation. When the REFILL TANK WHEN ON light glows, the bottle is empty. The tank is approximately
OPERATION (continued)
CAUTION:
BURN HAZARD
Exposed surfaces of dispenser and any container may be HOT to the touch, and can cause serious burns.
CAUTION:
BURN HAZARD
DO NOT fill water bottle with hot water. Splashing hot water can cause burns.
9
