SERVICING INSTRUCTIONS (continued)
PROCEDURE: Delime the Water Tank
PRECAUTIONS: Disconnect brewer from electric power.
| Allow brewer to cool. |
FREQUENCY: | As required (Brewer slow to heat) |
TOOLS: | Deliming Solution |
| Protective Gloves, Goggles & Apron |
| Mild Detergent, Clean Soft Cloth or Sponge |
| Bristle Brush, Bottle Brush |
| Large Sink (or other appropriate work area) |
1.Unplug power cord. Turn off the water
2.Remove the tank cover or water bottle assembly.
3.Mix 2 quarts of deliming solution according to the manufacturer’s directions. Carefully pour the deliming solution into the water tank. Allow to sit for 30 minutes, or as directed by the manufacturer.
4.At end of soaking period, drain deliming solution.
Using a stiff bristle brush, scrub the heating element and interior of the water tank to remove lime and calcium
5.Reconnect dispenser to electrical supply and reconnect water supply.
CAUTION:
CHEMICAL BURN
HAZARD
Deliming chemicals may be caustic. Wear appropriate protective gloves and goggles during this procedure.
Never siphon deliming chemicals or solutions by mouth.
This operation should only be performed by qualified and experienced service personnel.
IMPORTANT:
DO NOT spill, splash or pour water or deliming solution into or over any internal component other than the inside of the water tank.
IMPORTANT:
DO NOT allow any internal components to come into contact with the deliming solution. Take care to keep all internal components dry.
NOTE: Repeat steps 4 thru 5 as required to remove all scale and lime
19