FILTER LEAF ASSEMBLY
WARNING WARNING: BURN HAZARD
HOT OIL SPILL OR SPLATTER
DO NOT REMOVE FILTER RESERVOIR WHEN IT CONTAINS HOT OIL HOT OIL WILL CAUSE SEVERE BURNS ON CONTACT
PROTECTIVE CLOTHING AND GLOVES MUST BE WORN
DURING THE FILTERING PROCESS
Death or serious injury may result from contact with, or slipping and falling in, spilled oil.
WARNING WARNING: BURN HAZARD
DO NOT REMOVE FILTER RESERVOIR IF IT IS HOT.
WEAR INSULATED GLOVES OR ALLOW IT TO COOL.
Hot oil quickly heats reservoir. Touching hot reservoir
with bare hands can causing serious injury
363 30007 OpManual for
Clean FILTER LEAF after each day’s filtration, or as needed to return oil promptly to the kettle.
Open FRYER DOOR and slide the FILTER RESERVOIR forward to remove it. Remove FILTER LEAF from reservoir.
Disassemble FILTER LEAF by separating the two side rails at the joint with the straight pin. Clean all components in a sink with warm water and mild detergent, or in a dishwasher.
Assemble SCREEN with the SEPARATOR installed between the two screens. Verify that
BOTTOM SCREEN.
Slide screens into SIDE RAIL “B”
FILTER RAIL “A” | TOP VIEW | SIDE VIEW |
STRAIGHT |
|
|
PIN | UPPER |
|
FILTER SCREEN |
| |
| SEPARATOR |
|
| LOWER |
|
| FILTER SCREEN |
|
FILTER RAIL “B”
Install FILTER LEAF in RESERVOIR with suction tube firmly into filter drain hole.
Install filter reservoir into the fryer. Make sure the “O” ring closest to end of SUCTION TUBE is firmly seated in SUCTION LINE RECEPTACLE.
IMPORTANT: Make sure all oil is pumped into FRYPOT before removing reservoir.
NOTE:
When properly assembled, handle will point away from suction tube on BOTTOM SCREEN.
NOTE:
Inspect the “O” RING on FILTER SUCTION TUBE for damage. Replace “O” ring if it is cut, cracked or scuffed using one of the spare o- rings in the suction tube groove.
IMPORTANT:
Avoid contaminating the oil or food product by verifying that all components of filter reservoir assembly are completely dry before reassembling.
25