en
Note
Optimum rinsing and drying results can be obtained by using standard detergents in conjunction with separate application of salt and rinse aid.
Observance of the operating instructions or information on the packaging of the combined detergents determines their effectiveness.
Note
Even if the rinse aid and/or salt refill indicator is lit, the rinse programme runs correctly when 3in1 products are used.
If the rinse aid refill indicator 6 or salt refill 5 indicator is defective and you would like to switch it off, proceed as follows:
Switching the rinse aid refill indicator off and on
Hold down the programme button 3
and press the main switch 1 until the
digital display lights up, then release the buttons. 4 is indicated on the digital
display .
Each time the button 3 is pressed,
the set value increases by one; when
the value | is reached, the display |
jumps back to . To switch off, | |
select the | position. |
Switch off the main switch 1 ; the setting is saved.
Switching the salt refill indicator / water softening system off and on
Hold down the programme button B and switch on the main switch 1 , then release the buttons.
The illuminated button B and the
To change the setting: press the programme button B .
Each time the button is pressed, the set value increases by one; when the value is reached, the display jumps back
to (the salt refill indicator / water softening system has been switched off).
Switch off the main switch 1 . The set value is stored within the device.
Approx. 4 litres of water are required to regenerate the water softening system. As a result, the water consumption per rinse cycle increases by 0 to maximum
4 litres depending on the water hardness setting.
Note
If you use the detergent and rinse aid separately or switch from combined detergents to standard cleaning products, ensure that the rinse aid refill indicator has been switched on and the water softening system has been set to the correct water hardness.
16