Switching the dishwasher OFF

Several minutes after the programme has ended:

Open the door when the programme has ended.

Set main switch 1 to OFF.

Turn the water tap off.

(Does not apply when Aqua-Stop unit has been fitted)

Remove dishes, etc. when they have cooled down.

Interrupting the programme

Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until the spray arm has stopped rotating.

Set main switch 1 to OFF.

Indicator lights extinguish. The programme is retained in the dish- washer memory.

If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close.

Otherwise, the appliance door may fly open due to expansion.

In order to continue with the stored programme, set the main switch to ON again and close the door.

Time delay *

*on applicable models

You can delay the start of the programme in 1-hour steps up to 19 hours.

Switch on the appliance.

Press the timer programming button 3 until the digital display 4 jumps

to .

Keep pressing the timer programming button until the required time is displayed.

To delete the timer programming, keep pressing the button until is displayed.

You can change your programme selection at any time until the programme starts.

Remaining running time display

When the appliance has started, the expected programme running time is displayed. The programmed running time is affected by the water temperature, the number of dishes, as well as the degree of soiling. If these conditions are changed, the running time (depending on the selected programme) can vary greatly.

As the effect is not detected until a programme is running, the time may be longer or shorter than expected.

Intensive drying

If the ªIntensive dryingº function is activated, the temperature of the final rinse is increased in all programmes and you will therefore receive an improved drying result. (Note the higher temperature may not be suitable for fragile utensils.)

Hold down the programme button						A
and switch on the main switch.
Release both buttons.
The digital display			flashes			(on)
		4
or	(off).
To change the setting, press the
programme button			.
		A
Switch off the main switch					;
				1
the setting is stored.

Bosch Appliances 9000 035918 (8406 0) Switching the dishwasher OFF, Interrupting the programme

Models: 9000 035918 (8406 0)