en
Washing dishes
Reduce costs!
If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice.
Programme data
The stated programme data are based on standard operating conditions. The values can vary considerably according to:
different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage
Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only.
Water consumption values are based on a water hardness setting of 4.
Aqua sensor *
* on applicable models
The Aqua sensor is an optical measuring device which measures the turbidity of the rinsing water. A light barrier can detect dissolved food remnants in the water, e.g. egg, fat and oats.
The Aqua sensor is used according to the programme. When the Aqua sensor is active, ºcleanº rinsing water may be transferred into the next rinsing bath and/or the temperature adjusted. If the turbidity is greater, the water is drained and is replaced with fresh water. In this way the water consumption is reduced by approx. 4 litres for utensils which are ºlessº dirty.
Switching the dishwasher ON
Turn on the tap.
Set main switch 1 to ON. Indicators light up according to the last programme that was selected.
This same programme will run again if
no other programme button |
| 7 | is | ||
pressed |
|
|
| ||
The numerical display |
|
| shows the | ||
4 | |||||
expected duration of the programme. |
Close door.
The programme starts automatically.
Optical indicator during operation *
* With some models
During the rinse programme a light point appears on the floor below the device's door. Only open the dishwasher door when the light point has disappeared.
In the case of
End of programme
The end of the programme is indicated by a buzzer. This function can be changed as follows:±
Hold down Function button C pressed and switch on main switch
1, then let the buttons go.
Function Button C flashes, and the digital display indicates the value which was set at the factory
To change the setting:
Press Function button C .
Each depression of the button increases the set value by one, when is reached, the display jumps back to (off).
Switch off the main switch 1 .
The set value is stored in the appliance.
18