Fresh water connection
Using the enclosed parts, connect the fresh water connection to the tap according to the installation instructions. Ensure that the fresh water connection is not kinked, crushed or twisted.
When replacing the appliance, always connect a new water supply hose to the water supply. The old supply hose must not be
Water pressure:
Minimum 0,05 MPa (0,5 bar) ± maximum 1 MPa (10 bar).
If the water pressure is higher, install a pressure reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend that you use cold water. If you do use hot water, the temperature should not exceed 60 °C.
Electrical connection
Connect the appliance only to 230 V alternating current via a correctly installed socket with protective conductor.
See rating plate for required fusing 31 . The socket must be attached near the dishwasher and be freely accessible. The connection may be modified by an electrician only.
Use only a
symbol. Only this circuit breaker guarantees compliance with the currently valid regulations.
en
Removing the appliance
It is essential, when removing the appliance, to observe the following sequence: First, disconnect the appliance from the power supply.
Pull out the mains plug. Turn off the water supply.
Disconnect the waste water and fresh water connections.
Loosen the fastening screws under the worktop. If fitted, remove the base panel. Pull out the appliance, carefully pulling the hose behind.
Transporting the dishwasher
Drain water from the dishwasher. Secure all loose parts. The appliance should only be transported in an upright position.
If the appliance is not kept upright during transport, any water left inside may seep into the control module and cause subsequent errors with programme functions.
The appliance must be drained in the following sequence:
Turn on the tap.
Set main switch to ON.
Select the B programme. The programme duration in minutes is shown in the numerical display. Close the door.
Wait for approximately 4 minutes. Terminate the programme by pressing A and C simultaneously.
The time display changes to 
.
Wait a further minute and then switch the appliance off.
Turn off the tap.
Protection from freezing temperatures
If the appliance is installed in a location where there is a risk of freezing temperatures (e.g. in a holiday home), all water must be completely drained out of the interior (see ªTransporting the dishwasherº).
Turn OFF the tap, disconnect the supply hose and allow to drain.
27
