Indoor Pendant & | EN 9 |
|
|
1UNPACKING
Carefully remove the BasicDome camera module from the box. This camera module is the same one used in both the pendant and the
Also included in the box is a small ferrite (not shown) which snaps onto the power cable, providing additional EMI/RFI Interference protection.
Photo 1: Contents
CAUTION: Mounts must be properly and securely installed on a supporting structure capable of sustaining the unit weight.* Use care when selecting mounting hardware (not supplied) for installation. The mounting surface and the unit's weight should be carefully considered.
The following instructions reference a 24 VAC pendant arm installation mounted to an existing structure. The instructions assume the power, video, and control cables have already been properly installed.
*Refer to mounting instructions.
NOTE: SECTIONS 2.1, 2.2, and 2.3 refer to the Pendant Housings ONLY.
2.1Installation (Pendant Housings)
For pendant models, the mount should already be installed according to the specific mounting instructions included with the mount. Mounts come with screws installed that are used with other dome products, and should be removed and discarded. A safety cable may be included, but is not used with the BasicDome, and should be removed and discarded to avoid possible contact with the PC board inside the pendant.
2INSTALLATION
ATTENTION: Installation should be performed by qualified service personnel only, in accordance with the National Electrical Code or applicable local codes. Refer to applicable installation section.
The BasicDome can be mounted to a wall, mast (pole), roof, pipe, corner, or suspended ceiling. You must have installed the appropriate mount before installing the BasicDome. Each mount includes its own instructions. Once the mount is installed and wired according to
those instructions, proceed to the next step. ForPhoto 2: Remove Existing Screws suspended ceiling installations, proceed to STEP 2.4.
Bosch Security Systems 10 December 2003
