Indoor Pendant & | EN 12 |
|
|
3TRIM RING REPLACEMENT
The Camera Module ships with an optional trim ring. If the trim ring currently installed on the camera module does not match the color of your pendant or ceiling décor, simply replace it with the one provided by following these steps.
1.With a slotted screwdriver, carefully pry each of the six (6) trim ring tabs away from the camera module, as shown in PHOTO 11. Take extra care not to allow the dome surface to come in contact with anything that could scratch it.
Tabs
Tabs
Photo 11: Pry Tabs away from Camera Module
2.Position the new trim ring so that the hole aligns with the locking screw, as shown in PHOTO 12.
Hole
Locking
Screw
3.Using a slotted screwdriver, carefully pry the trim ring tabs while pressing on the trim ring at the same time. It may help to use the edge of a table while doing this, but again, be sure not to allow the dome surface to come in contact with anything that might scratch it. Secure all six (6) tabs, as shown in PHOTO 13.
Photo 13: Secure Trim Ring
Photo 12: Position Trim Ring
Bosch Security Systems 10 December 2003
