Door Panel Installation
DOOR PANEL INSTALLATION
25” (636 mm)
(586 mm)
B
1/4” max.
(6 mm)
Figure 16
Figure 17
A
Accessory Panel Installation Kits (select models)
This kit allows you to install a custom panel (up to 1/4” thick) on your dishwasher. The panel dimensions are shown in Figure 16. Install the panel before sliding the dishwasher into place. Contact Customer Service to see if a kit is available for your model and to obtain ordering instructions.
Fully Integrated Models
Fully integrated models allow you to have a custom door panel made to match your cabinetry. The custom door can be a
NOTE: The door springs that are included with the Fully Integrated units will provide proper function for custom door panels weighing between 9 and 15 pounds. Custom Door panels weighing up to 18 pounds require the use of the Tension Adjustment Screws (See page 14 for details
on the proper use of the Tension Adjustment Screws).
Fig. 17 | Integrated Panel Dimensions for | |
Dimension | Custom Door Panels | |
| ||
|
| |
A | 27 3/16” - 30 7/16” | |
(690mm - 774mm) | ||
| ||
|
| |
B | 23 3/16” - 23 3/8” | |
(589mm - 594mm) | ||
| ||
|
|
PLACING THE DISHWASHER
14" | 1 Straighten and position the hot water supply line and | ||
| (355mm) | ||
| the electrical supply cable as shown in Figure 18 so | ||
|
| ||
|
| that they will align with their channels under the | |
21" | |||
dishwasher base. | |||
| (533mm) | ||
|
| 2 Position the dishwasher close enough to the | |
Figure 18 | enclosure so that you can run the dishwasher drain | ||
hose to the under sink drain connection. Make certain | |||
|
| ||
|
| that the hot water supply line and the electrical supply | |
| Figure 19 | cable are in their channels under the dishwasher | |
| base, as shown in Figure 19. |
3Slide the dishwasher into the opening making sure that the hot water supply line and the electrical supply
| cable stay in their proper channels. | |
| 4 Make sure the dishwasher is level. Adjust the rear | |
| leveler by turning the center screw at the front of the | |
| dishwasher, as shown in Figure 20a. Turning the | |
| screw clockwise raises the rear of the dishwasher. | |
| Adjust the front levelers by turning them with a | |
| screwdriver, as shown in Figure 20b. Turning the | |
| levelers to the right raises the dishwasher. If additional | |
Hot Water Supply Line | height is needed, shims may be added under the | |
leveler feet. | ||
and Electrical Supply | ||
| ||
Cable Position in |
| |
Channels |
|
10