Placing the Dishwasher/ Securing the Dishwasher
Figure 20
a
b 
SECURING THE DISHWASHER
1Drive the mounting screws through the holes in the mounting brackets as shown in Figure 21 for Top or Side Mount.
2After the unit is installed in the enclosure, leveled and secured, lock the two front leg levelers in place by driving the enclosed leg leveler locking screws into each screw boss located in front of the levelers. See Figure 22.
3Tighten screws until they are flush with the surface of the bosses.
Top Mount
Figure 21
Figure 22
Installation of the Rubber Drain Hose
1 | Adaptor |
Obtain the Rubber Drain Hose Adaptor and the two | |
| hose clamps from the Dishwasher Installation Kit (do |
| not substitute). |
2 | On one outside end of the Rubber Drain Hose |
Side Mount | Adapter is a raised rib. Insert the dishwasher drain |
hose into the end without the raised rib (see Figure | |
| 23). Be sure to fully insert the drain hose. |
3 | Secure the connection with the Spring Clamp (see |
| Figure 24). |
4 | Use the Screw Clamp to attach the Rubber Drain |
| Hose Adaptor to the house plumbing (see Figure 24). |
Leg
Leveler
Locking
Screw
Screw
Boss
Rubber Drain Hose Adaptor |
|
Raised Rib (cross section) | Dishwasher |
| Drain Hose |
| | | |
Connects to house- |
| ||
Insert until drain | |||
hold plumbing | |||
| hose locks in place | ||
Figure 23
Raised | Spring | |
Clamp | ||
Rib on |
| |
Outside | Screw | |
of Drain | ||
Clamp | ||
Hose | ||
| ||
Adaptor |
|
Figure 24
11
