Bosch Appliances BSH Dishwasher BASE AND TOE PANEL Continued, Final Instructions

Base and Toe Panel/ Final Instructions

ca

b

d

Figure 36

BASE AND TOE PANEL (Continued)

Method B - Plastic Base Access Panel and Toe Panel Installation (select models)

1Place the Plastic Base Access Panel under and up the front bottom panel of the dishwasher, as shown in Figure 36a.

2Insert the Plastic Base Access Panel screws into the Plastic Base Access Panel, as shown in Figure 36b. Tighten the Plastic Base Access Panel Screws.

3Place the Cotton Insulation Strip under the unit, between the bottom of the Plastic Base Access Panel and the floor, as shown in Figure 36c.

4Attach the Metal Toe Panel to the Plastic Base Access Panel using the Toe Panel Screws included in the Toe Panel Installation Kit. See Figure 36d.

NOTE: You will not use the normal Toe Panel Screws included in the Dishwasher Installation Kit on these models.

WARNING

In some conditions, Hydrogen gas can form in a hot water system that has not been used for weeks. Hydrogen gas is explosive. Before filling a dishwasher from a system that has been off for weeks, run the water from a nearby faucet in a well ventilated area until there is no sound or evidence of gas.

FINAL INSTRUCTIONS

1Energize the dishwasher power supply circuit.

2Consult the Dishwasher Use and Care Manual, and run the dishwasher through one complete cycle. If the dishwasher does not operate properly, refer to the Self-Help section of the Use and Care Manual. If the dishwasher still does not operate properly, refer to the Customer Service Section of the Use and Care Manual.

15