Bosch Appliances DIE 165 R manual Replacing the light bulbs, If you encounter a problem

Replacing the light bulbs

1.Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box.

CAUTION:

When switched on, the halogen bulbs become very hot. Even for some time after the bulbs have been switched off there is still a risk of burns.

2.Remove the bulb ring with a screwdriver or similar tool.

3.Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. 20 Watt, G4 cap).

NOTE: Refer for plug-in lampholder. Take hold of the bulb with a clean cloth.

4.Re-insert the bulb ring.

5.Plug the appliance into the mains or switch it on at the fuse box.

NOTE:

If the light does not function, check that the bulbs have been inserted correctly.

If you encounter a problem

If an # appears in the display:

❑See "Filters and maintenance" Section.

If is not possible to operate the extractor hood:

❑Disconnect the extractor hood from the mains electricity supply by pulling out the plug or switching it off at the main fuse box.

Wait for approx. 1 minute and then switch it on again.

If you have any questions or if a fault occurs, please call Customer Service.

(See list of Customer Service representatives).

When you call, please quote the following:

E-Nr. FD

Enter the relevant numbers into the box above. The E-Nr. (product no.) and FD (production date) are shown on the nameplate which can be seen inside the extractor hood after the filter frame has been detached.

IMPORTANT:

The manufacturer of the extractor hoods accepts no liability for complaints which can be attributed to the design and lay- out of the pipework.

9