Service

The OvenTable 13: Oven Troubleshooting Chart
Oven ProblemPossible Causes and
Suggested Solutions

 

 

 

Element cycles on the highest setting

This is normal. The temperature limiter operates automatically to protect

 

the glass ceramic surface from extreme high temperature damage.

 

 

The oven mode or temperature selected

The knob was turned too rapidly. Turn knob slower until correct wording or

or the numbers selected do not appear in

temperature appears. Review manual instructions when setting clock,

the display

timer, or Self-Clean.

 

 

Oven door is locked and will not release,

Turn the oven off at the circuit breaker and wait 5 minutes. Turn breaker

even after cooling

back on. The oven should reset itself and will be operable.

 

 

Oven is not heating

Check circuit breaker or fuse box to your house. Make sure there is proper

 

electrical power to the oven. Be sure oven temperature has been selected.

 

 

Oven is not cooking evenly

Adjust oven calibration if necessary (see Oven Temperature Offset). Refer

 

to cooking charts for recommended rack position. Always reduce recipe

 

temperature by 25°F when baking in Convection Bake mode.

 

 

Oven temperature is too hot or too cold

The oven thermostat needs adjustment. See Oven Temperature Offset.

 

 

Oven light is not working properly

Replace or reinsert the light bulb if loose or defective. Touching the bulb

 

with fingers may cause the bulb to burn out.

 

 

Oven light stays on

Check for obstruction in oven door. Check to see if hinge is bent.

 

 

Cannot remove lens cover on light

There may be soil build-up around the lens cover. Wipe lens cover area

 

with a clean dry towel prior to attempting to remove the lens cover.

 

 

Oven will not Self-Clean properly

Allow the oven to cool before running Self-Clean. Always wipe out loose

 

soils or heavy spillovers before running Self-Clean. If oven is badly soiled,

 

set oven for a five-hour Self-Clean. See Preparing the Oven to Self-Clean.

 

 

Clock and timer are not working properly

Make sure there is electrical power to oven. See Clock and Timer sections.

 

 

Porcelain chips

When oven racks are removed and replaced, always tilt racks upward and

 

do not force them to avoid chipping the porcelain.

 

 

“F” and a number appears in display and

This is a fault code. Press Off to clear the display and stop beeping. Reset

control beeps

oven if necessary. If fault code remains and beep continues, record fault

 

code, cancel oven and call authorized service technician.

 

 

With a new range there is a strong odor

This is normal with a new range and will disappear after a few uses. Oper-

when oven is turned on

ating the self-clean cycle will also “burn-off” the smell more quickly.

 

 

English 35