[] CONVERTTHE SURFACEBURNERS
Top Grate
Burner Cap
@
1.Remove grates and burner caps.
2.Using the 7 mm nut driver, remove and replace the brass orifice spud inside each burner chimney as follows:
•Replace the large orifices with the spuds that are stamped 104.
•Replace the small orifices with the spuds that are stamped 82.
NOTE: There will be one extra orifice spud when
converting a four burner cooktop.
CONVERTTHE PRESSUREREGULATOR
WARNING: Do not remove the pressure I regulator from the cooktop.
1.Locate the pressure regulator under the rear of the cooktop.
2.Use an adjustable wrench to remove the
nut from the pressure regulator.
\ | _ | Gas | Flow |
,___ |
| into | Range |
|
|
| LP |
|
| t | |
NAT_ | Nut | ||
3. Insert the LP Adapter into the nut. |
| ||
NAT | LP |
|
|
i
Nut
4.Reinsert the assembly into the regulator and attach the
(continued next page)
19
