Bosch Appliances JGP641 Fully screw down the brass low flame, clockwise rotation, and cams

This cooktop leaves the factory set for use with natural gas. If you convert to LP gas, keep these

instructions and orifices in case you want to convert back to natural gas.

The conversion should be done by a qualified

technician or installer.

PARTS:

Check the contents of the kit, which should contain the following:

•2 Orifice--Large size--104-WB28K0093

•2 Orifice--Regular size--82-WB28K0094

•1 Maxitrol LP adapter--WB01K055

•1 Tie-on card/label for regulator

Ifyou do not have all the above listed components,

or if you are in any doubt, please contact the nearest GE Service and Parts Center.

USE ONLY APPROVED PIPE DOPE RESISTANT TO LP GAS.

Total input rating after conversion:

• 4 burner cooktop 34,000 Btu/hr.

TOOLSREQUIRED:

Adjustable wrench

Nut drivers: 9/32" or 7 mm

[_ PREPARE COOKTOP FOR CONVERSION

(1)Turn off gas supply at the wall.

(2)Turn off the electrical power to the cooktop.

_1 CONVERTTHE SURFACEKNOBS

1.Remove the knobs and lift off the microswitch

operating cams	from
the valve shafts.	o_	/	Cam

Shaft

,__Valve

• , o .

2.Fully screw down the brass low flame

adjustment screws into the valve bodies with a

clockwise rotation.

3. Replace the knobs	LO
and cams.

18