Installation
toverifythatbothbacklegsarerestingsolidlyonthefloor.Alsoverifythatthe
Caution:
Verifythattheweightoftherangeisnotrestingonthecountertop. Thiscouldresultin damageto thecountertopandtheappliance.
3.If the back legs are not resting solidly on the floor or the left leg is not under the
Test for Gas Leaks
Adjust Front of Range for Proper Installation
1.Adjust front leveling legs so that the cooktop trim rests against the countertop all the way around.
2.Verify that both front legs are resting solidly on the floor.
3.Use a level to verify that the range is level and plumb.
4.Push range back into position ensuring that range leg slides under the
5.Carefully tip range forward to ensure that
Complete Gas Connection
1.Connect pipe to range at union. Access the connection through the access panel behind the drawer.
The gas connection is complete. Proceed to "Test for Gas Leaks" on page 21.
Leak testing is to be conducted by the installer according to the instructions given in this section.
Note:
Be careful not to apply pressure to warming drawer element during rigid pipe testing.
1.Turn on gas.
2.Apply a
3.Inspect for leaks. Bubbles appearing around fittings and connections indicate a leak.
4.If a leak appears, turn off supply line gas shutoff valve and tighten connec- tions.
5.Retest for leaks. Turn gas back on at supply line shutoff valve and reapply leak detection fluid.
6.When no bubbles appear, test is complete. Wipe off all detection fluid residue.
Caution:
Never check for leaks with a flame.
Do not continue to the next step until all leaks are eliminated.
English 21