Bosch Appliances LTC 8016/90 instruction manual En, Bosch Security Systems 18 August

LTC 8016/90 Instruction Manual Installation EN 11

4.4.2Switch Settings When Interfacing to Biphase Controller Devices

When using a biphase data interface, the Group ID switches must be set to correspond to a block of 16 logical camera numbers between 1-16 and 9985-9999. Since each block consists of 16 numbers, the Group ID number for these cameras range from 1 to 625. The Group ID number selected must not duplicate Group ID numbers already used.

The Interface Unit is set to 901 by default, and no change is required when only one Interface Unit is used in a system for cameras 1 to 16. Otherwise, use the supplied screwdriver to set the Group ID

to correspond to the logical camera number range shown in the table below. For larger systems, refer to APPENDIX A for additional Group ID switch settings.

Group ID	Camera	Group ID	Camera	Group ID	Camera
Switches	Number	Switches	Number	Switches	Number
	Range		Range		Range
001	1 to 16	023	353 to 368	045	705 to 720
002	17 to 32	024	369 to 384	046	721 to 736
003	33 to 48	025	385 to 400	047	737 to 752
004	49 to 64	026	401 to 416	048	753 to 768
005	65 to 80	027	417 to 432	049	769 to 784
006	81 to 96	028	433 to 448	050	785 to 800
007	97 to 112	029	449 to 464	051	801 to 816
008	113 to 128	030	465 to 480	052	817 to 832
009	129 to 144	031	481 to 496	053	833 to 848
010	145 to 160	032	497 to 512	054	849 to 864
011	161 to 176	033	513 to 528	055	865 to 880
012	177 to 192	034	529 to 544	056	881 to 896
013	193 to 208	035	545 to 560	057	897 to 912
014	209 to 224	036	561 to 576	058	913 to 928
015	225 to 240	037	577 to 592	059	929 to 944
016	241 to 256	038	593 to 608	060	945 to 960
017	257 to 272	039	609 to 624	061	961 to 976
018	273 to 288	040	625 to 640	062	977 to 992
019	289 to 304	041	641 to 656	063	993 to 1008
020	305 to 320	042	657 to 672	064	1009 to 1024
021	321 to 336	043	673 to 688
022	337 to 352	044	689 to 704

Bosch Security Systems 18 August 2005