LTC 8016/90 Instruction Manual Unpacking | EN 7 |
|
|
1.0UNPACKING
This equipment should be unpacked and handled with care. If an item appears to have been damaged in shipment, notify the shipper.
Verify that all parts shown in the Parts List have been included. If any items are missing, notify your Bosch Security Systems Sales or Customer Service Representative.
The original packing carton is the safest container in which to transport the unit. Save it for possible future use.
1.1Parts List
Qty | Item |
1 | LTC 8016/90 |
|
|
2 | AC power cords (one for 120 VAC, and one for |
| 220 - 240 VAC) |
1 | 2 m (6 ft) |
|
|
1 | 3 m (10 ft) Data interface cable |
|
|
1 | |
|
|
2 | |
|
|
1 | Offset screwdriver (star & slot ends) |
|
|
1 | This installation manual |
|
|
2.0SERVICE
If the unit needs repair, contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions.
Service Centers
USA
Phone:
CCTV Spare Parts
Phone:
Phone:
Europe, Middle East & Asia Pacific Region Phone:
For additional information, see www.boschsecurity.com.
3.0DESCRIPTION
3.1General
The LTC 8016 Allegiant Bilinx Data Interface Unit is an accessory device used to provide
When connected to a
Camera setup is simplified when the Interface Unit is used with the AutoDome Series of P/T/Z cameras, since programming of the dome camera address is no longer required. In addition to conventional CCTV coax, configuration solutions are available for other compatible video/data transmission products, such as unshielded twisted pair (UTP) products and fiber optic links.
3.2 Power
Model | Rated | Voltage | Nominal |
No. | Voltage | Range | Power |
LTC 8016/90 | 120 /230 VAC, | 105 to 253 | 15 W |
| 50/60 Hz |
|
|
3.3 Compatibility Information
Although any device generating a standard video signal can be connected to the Allegiant Bilinx Data Interface Unit, it is only capable of communicating with devices that are compatible with Bilinx technology.
If the unit is being connected to any of the following devices, they must meet the following minimum specifications:
•Allegiant Series Switcher/Controller firmware 8.6 (released May, 2004) or later is required if using the Allegiant data interface connection.
•AutoDome Series Camera models with firmware 5.11 (released October, 2003) or later is required.
•Dinion Series Cameras that were manufactured after March 2004.
Bosch Security Systems 18 August 2005