Bosch Appliances LTC 8016/90 6.0OPERATION, 7.0DEVICE OUTLINE, 8.0CONNECTOR AND CABLE PINOUTS, En

LTC 8016/90 Instruction Manual Operation EN 20

6.0OPERATION

Once installation is finished, operation of this unit is completely automatic. Refer to the applicable section of the manual supplied with the control device and/or camera for details regarding their features/functions.

The Interface Unit is designed to process camera contact alarm and motion event messages from cameras that support this functionality. The Interface Unit can also detect Dark Alarm signal conditions when the

video amplitude level drops below 15 IRE. When the Interface is connected to an Allegiant system using the Allegiant data interface, messages can be sent to the controller to notify the system of these events. By default, camera contact alarm input 1 will result in a standard Allegiant system alarm response, assuming an alarm response mode has been configured in the system. System responses to camera alarms 2 to 4, and the Dark Alarm require programming of the Allegiant system using the PC-based Allegiant LTC 8059 Master Control Software, version 2.7 or later.

7.0DEVICE OUTLINE

Allegiant Bilinx Data Interface	BOSCH
	Status/Power

Figure 17 Front Panel

			CODE				ETHERNET
						10/100 BaseT
						LINK	ACT	15	13	11	9
PC	RS-485 IN
DATA		BIPHASE IN							INPUTS
			0		0		0
		8		8		8
			2		2		2		14	12
RS-232	RS-485 OUT	6	4		6 4		6 4	16			10

GROUP ID

LOOPING VIDEO 1-16

. . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . .

7	5	3	1
8	6	4	2

Figure 18 Rear Panel

8.0CONNECTOR AND CABLE PINOUTS

8.1LTC 8016 Connector Pinouts

	6-Position CODE Connector1
Pin	Connection
1	Shield

2Biphase Data --

3 Biphase Data +

4Shield

5Biphase Data --

6 Biphase Data +

1Pins are not numbered; the numbers represent the pin sequence from left to right.

9-Pin PC Connector

Pin	Connection	Old Pinouts2
1	––	––
2	Rx	Tx
3	Tx	Rx
4	––	––
5	Data Gnd	Data Gnd
6	––	––
7	RTS	CTS
8	CTS	RTS
9	––	––

2Pinouts used on units manufactured before July, 2004 (date code 0426).

	9-Pin RS-232 Connector
Pin	Connection
1	Data Gnd
2	RTS
3	CTS
4	Tx
5	Rx
6	––
7	Data Gnd
8	––
9	––
	9-Pin RS-485 IN Connectors
Pin	Connection
1	––
2	TXD+
3	TXD--
4	RXD+
5	RXD--
6	––
7	––
8	––
9	––

Bosch Security Systems 18 August 2005