Bosch Appliances Nexxt DLX Water connection, Water supply, Connection, Observe the water pressure

- The water pressure should be To prevent water damage, the

between 14.5 and 145 p.s.i. hot and cold water valves should

(1 and 10 bars) when the tap be accessible when the washing is turned on, at least 2.2 U. S. machine is in place and should gallons (8 liters) of water should always be turned off when the

be discharged per minute. washing machine is not in use.

Water connection	Observe the water pressure in the
	supply network:

Water supply

CAUTION

The washing machine must only
be operated with cold and hot
(max. 140 °F /		60 °C) tap water.
Do not	connect	the	appliance to -	A pressure regulator valve must
the mixer tap of an			unpressuri5	be installed if the maximum
zed hot5water boiler.				water pressure is exceeded.
If in doubt, have the water
connection	installed by		an
authorized	technician.

The water supply hoses must not be:

-Bent or flattened.

-Modified or cut (stability can no longer be guaranteed).

Plastic threads must only be tightened by hand. Do not remove the strainers from the water supply hoses.

Connection

C Cold water connection and

H Hot water connection (max. °140F/ 60°C)

CAUTION

CAUTION

If installing the washing machine

in a new building or a building in which the plumbing system was recently installed or upgraded, flush the lines before installing

the washing machine to remove any sand, dirt or residue.

min.0,4'' (10 mm)

qAfter the connection,

Turn on the water completely, and check that connection points are watertight.

d CAUTION d

The connection points are under full water pressure. Check seal with tap fully open.

10