ADDING RINSE AGENT
Rinse Agent
Rinse agent, or a rinse aid, is used to provide optimum drying results and diminish water spot- ting. Always use a rinse agent with the Bosch dishwasher to insure proper drying results. It rinses the dishware and also rinses the internal parts of the dishwasher.
To Fill the Rinse Agent Reservoir:
1.Open the dishwasher door fully.
2.Open the cover of the rinse agent dispenser by pressing the star on the cover with your index finger while pulling on the tab with your thumb.
3.Add rinse agent to the reservoir until the level indicator turns dark, indicating that the reservoir is full (capacity is approx. 3.5 oz.).
Rinse Agent
Dispenser Regulator
The rinse agent reservoir of the Bosch dishwasher is provided with a regulator calibrated from 1 to 6. (See Figure 21.) This regulator controls the amount of rinse agent dispensed. The dishwasher leaves the factory preset to 4. However,
•if you see streaks, you should turn the regulator to a lower number.
•if you see water spots, you should turn the regulator to a higher number.
TO ADJUST RINSE
AGENT REGULATOR
SETTING:
1. OPEN THE COVER OF THE RINSE AGENT DISPENSER.
2.TURN THE SETTING INDICATOR TO THE DESIRED SETTING.
Figure 21
Note: Refill rinse agent when the level indicator shows a silver background with black lines.
Rinse agent level indicator
Figure 22
Rinse agent is available in liq- uid or solid form. Only use the liquid type of rinse agent in the Bosch dishwasher.
Rinse Agent Indicator Light
Some models are equipped with an additional rinse |
|
aid indicator light on the control panel. When the |
|
rinse agent dispenser is empty, the indicator light will |
|
glow and the level indicator will show a silver back- |
|
ground with black lines. |
|
After filling the rinse agent dispenser, close the door | Figure 23 |
and wait a few minutes for the indicator light to reg- |
|
ister. |
|
www.boschappliances.com ENGLISH - 13