Bosch Appliances WFL 2060UC, WFR 2460UC, WFR2460UC WFL 2060 & WFR 2460 Service Tips

WFL 2060 & WFR 2460 Service Tips
WFL 2060 & WFR 2460 Service Tips --
--
Troubleshooting (3)
Troubleshooting (3)
75
Symptom Problem Solution
Washer overheats.  Control module has
failed.
 NTC failed.
 Check voltage to heater. If voltage is present when heater
shouldn’t be on, replace faulty control module.
 Disconnect NTC and measure resistance at terminals (~ 5.4 –
6.5 kΩ @ 20ºC (68ºF)). Replace NTC if faulty.
Door won’t lock.  Door isn’t closed
properly.
 Door latch is broken.
 Door lock has failed.
 Close door securely. If door won’t latch, check door latch and
door hinge alignment.
 Replace broken door latch.
 Measure resistance of door lock mechanism (~ 500 – 1500 Ω for
WFL 2060 or 211 – 259 Ω for WFR 2460). Replace faulty door
lock mechanism.
Washer won’t spin
over 800 RPM
(WFR 2460) .
 Replacement control
module wasn’t
configured when
installed.
 Use test T5 on test program (pp. 43, 61) to configure control
module to U.S. settings (42010011).
Washer has wrong
wash cycles and hot
water inlet doesn’t
work (WFL 2060).
 Replacement control
module wasn’t
configured when
installed.
 Use instructions on page 42 to set dipswitches on control
module (p.c. board) to U.S. settings.
WARNING!Unplug washer before starting any repairs.
1st Edition/Revision 5 (1/20/04)