Divar XF | Hardware setup en 25 |
|
|
Placing a hard disk
Figure 4.4 Placing a hard disk
1.Locate the first empty hard disk bay. It is recommended that you install the disks in order from one to four, as labeled. (Note that disks 3 and 4 are mounted in a double bay.)
2.Unscrew the two torx T10 screws securing the selected bay. Slide the bay from the unit by pulling it forward.
3.To replace an installed hard disk, remove the four installation screws, two per side, from the sides of the bay. Remove the hard disk.
Mount the new hard disk into the bay with four screws, two per side (refer to the hard disk documentation).
4.Align and slide the bay back fully into its slot in the unit.
5.Secure the bay using the two torx T10 screws removed earlier (step 2).
6.Repeat steps
Remounting the front panel
1. When disk installation is complete, reconnect the flat cable to the front panel, if necessary.
2. Align and slide the front panel to the left until it is in place.
3. Refasten the two captive cross head screws to the front panel.
4.4Camera connections
Connect cameras to the Video in connectors on the back of the unit using 75 ohm video coaxial cables with BNC connectors. Optionally, this signal can be looped through to other equipment via the corresponding Video out connector. The camera input connectors are auto-
Bosch Security Systems | Installation manual | F.01U.135.429 2.5 2009.08 |
