Bosch Appliances XF 6.7.2Contact, 6.7.3Motion, 6.7.4Video loss, Sound beeper on alarm, Actions

64 en Advanced configuration menu Divar XF

–Follows - activates the beeper, relay, and view only as long as the event is present.

Sound beeper on alarm

–Enable an audible warning upon an alarm.

Sound beeper on video loss

–Enable an audible warning upon video loss.

Actions when entering this profile

Click Edit... to specify pre-positions for PTZ cameras when this profile is started.

–Enter a pre-position value from 1-1023 for each of the PTZ cameras that should be moved (PTZ must be enabled for corresponding camera input).

Any actions that have been configured are listed.

6.7.2Contact

The event behavior can be configured for each of the 16 input contacts in turn.

–Check the Enabled box if the input contact should activate an event.

–Check the Alarm box if the input contact should activate an alarm.

Actions

Click Edit... to set up Recording, Monitor and PTZ actions that should be carried out when this contact is active.

–Recording: highlight the video channels to be recorded at contact recording settings when this input contact is active (highlight the un-numbered box to select all). A list of the selected channels and their recording properties is shown.

–Monitor: highlight the video channels to be displayed on monitors A and B when this input contact is active (highlight the un-numbered box to select all).

–PTZ: enter a pre-position value from 1-1023 for each of the PTZ cameras that should be moved (PTZ must be enabled for corresponding camera input).

Any actions that have been configured are listed.

6.7.3Motion

The event behavior for motion detection can be configured for each video channel in turn.

–Check the Enabled box if motion detection should activate a trigger.

–Check the Alarm box if motion detection should activate an alarm.

Actions

Click Edit... to set up Recording, Monitor and PTZ actions that should be carried out when motion is detected.

–Recording: highlight the video channels to be recorded at motion recording settings when motion is detected (highlight the un-numbered box to select all). A list of the selected channels and their recording properties is shown.

–Monitor: highlight the video channels to be displayed on monitors A and B when motion is detected (highlight the un-numbered box to select all).

–PTZ: enter a pre-position value from 1-1023 for each of the PTZ cameras that should be moved (PTZ must be enabled for corresponding camera input).

Any actions that have been configured are listed.

6.7.4Video loss

The event behavior for video loss signals can be configured for each video channel in turn.

– Check the Enabled box for each video channel if video loss should activate a trigger.

F.01U.135.429 2.5 2009.08 Installation manual Bosch Security Systems