24 en Hardware setupDivar XF
CAUTION!
When installing the assembly into the rack, be careful not to restrict air flow around the vents located on the side panels or to exceed the recommended operating temperature.
Secure the connection cables to the rack to relieve excessive weight to the back of the unit.
4.3 | Hard disk installation | |
|
| Up to four hard disks can be installed in the DVR. All hard disks are accessed from the front of |
|
| the unit by removing the front panel. Do not open the top cover or attempt to service the unit. |
|
| No user serviceable parts inside. Refer all servicing to qualified service personnel. Improper |
|
| handling or installation could void the warranty of both the hard disk and the DVR. |
|
| Note! Only genuine Bosch hard disks will work in the Divar XF. See the Bosch website or |
|
| contact your local Bosch representative for available hard disks. |
|
|
|
|
| CAUTION! |
|
| |
|
| Electrostatic discharges |
|
| Any electrostatic energy coming in contact with the hard disk or other sensitive internal parts |
|
| can damage them permanently. Improper handling could void the warranty of the hard disk. |
|
| When working with electrostatic sensitive devices such as a hard disk or the Divar unit, make |
|
| sure you use a |
|
| |
|
|
|
4.3.1 | Mounting instructions | |
|
|
|
|
| DANGER! |
|
| Electrical voltage. |
|
| Risk of electric shock. |
Before installation of the hard disk, unplug the power cord of the DVR and wait for at least 30 seconds.
Removing the front panel
Divar
Figure 4.3 Front panel removal
1.Loosen the two captive cross head screws on the bottom front panel.
2.Slide the front panel to the right until it is free.
3.Place the front panel on top of the unit, taking care not to strain the flat cable. If there is no room on top of the unit, disconnect the flat cable and set the front panel aside.
F.01U.135.429 2.5 2009.08 | Installation manual | Bosch Security Systems |
