SIMATIC Box PC 620 Expansions

4.5.3Removal and Installation of the Floppy Drive

1.Open the housing as described in Section 4.1.

2.Remove the drive holder as described in Section 4.5.1.

3.Release the interlock of the controller flex-lead on the motherboard and pull the flex-lead out of the connector assembly.

4.Undo the two fixing screws (TORX T8) on the housing.

5.Lift the floppy drive upwards out of the housing.

6.Proceed in the reverse order to fit the new drive. The new drive must be of the same type as the one removed.

Fixing screws of the floppy drive

Figure 4-15 Installation of the Floppy Disk Drive in the Box PC 620

4-20

SIMATIC Box PC 620 Manual

A5E00131465-01

Page 80
Image 80
Siemens 620 appendix Removal and Installation of the Floppy Drive, Installation of the Floppy Disk Drive in the Box PC