
Configuring the SIMATIC Box PC 620
Primary Master Primary Slave Secondary Master/ Secondary Slave
The system jumps to the following submenu when you select this type of menu field:
PhoenixBIOS Setup Utility
Main
|
|
|
|
|
|
|
| Primary Master [20496 MB] | Item Specific Help |
| |||
|
|
|
|
|
|
|
|
|
|
|
| [Auto] (recommended) |
|
| Type: | [ | Auto | ] |
| |
| Autotypes installed |
| ||||
| LBA Format |
| ||||
| Total Sectors: | 40031712 | [USER] |
| ||
| Maximum Capacity: | 20496 MB |
| |||
| Enter parameters of |
| ||||
|
|
|
|
|
| |
| [16 Sectors] |
| ||||
| at this connection |
| ||||
| LBA Mode Control: | [Enabled] |
|
| ||
| 32 Bit I/O: | [Enabled] |
|
| ||
| Transfer Mode: | [FPIO 4 / DMA 2] |
|
| ||
| Ultra DMA Mode: | [Disabled] |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
F1 Help ESC Exit
Select Item | + / – | Change Values | F9 | Setup Defaults | |
Select Menu | Enter | Select | F10 | Save and Exit |
Figure 5-3 Primary Master
“Type” Field
The parameters you can select here are usually stored on the IDE drive. The ’Auto’ setting in the ’Type’ field means that these values are automatically read from the drive and written into memory (Autodetect).
If Type is selected for a drive that cannot be detected, a timer times out in approximately 1 minute and the entries remain unchanged. You should always check that the interfaces for which you select ’Auto’ are in fact connected to drives.
Select “User” if you want to define the
SIMATIC Box PC 620 Manual | |