Error Diagnosis

6.1Problems When Using Modules from Other Manufacturers

Error Display

The PC crashes during power up.

Cause

The following causes are possible:

Double assignment of I/O addresses

Double assignment of hardware interrupts and/or DMA channels

Signal frequencies or signal levels are not met

Different connector assignments

Remedy

Check your computer configuration:

SIf the computer configuration is the same as when your PC was delivered, please contact your technical support team (Chapter 8).

SIf the computer configuration has changed, re-establish the configuration you had when your PC was delivered. Remove any modules from other manufactu- rers. Perform a complete restart on your PC.

If the PC still crashes, you must contact your technical support team.

If the error no longer occurs, the module you used from another manufactu- rer was the cause of the fault. Replace this module with a Siemens module, or contact the module supplier.

6-2

SIMATIC Box PC 620 Manual

A5E00131465-01

Page 122
Image 122
Siemens 620 Problems When Using Modules from Other Manufacturers, Error Display, Cause, Remedy, PC crashes during power up