Cooper Bussmann BU-945U-E 802.11 DSSS Dhcp Client Configuration, Channel Selection, Max Distance

Models: BU-945U-E 802.11 DSSS

1 82
Download 82 pages 13.84 Kb
Page 30
Image 30

Cooper Bussmann Wireless Ethernet & Device Server BU-945U-E 802.11 DSSS User Manual

Radio Mode

BU-945U-E Only Supports the 802.11 Standard

Background Scanning (STA only)

Enabling this option will allow a modem to periodically rescan for Access Points keeping the connectivity

 

page up to date with current system information. Default is off. Note: Enabling this option will slightly

 

increase overall radio communications. Rescan time is fixed at 300sec (5min).

Max Distance

Configure the maximum distance the radio signal is expected to travel. This allows the modem to

 

Compensate for the flight time of messages as they pass from the transmitter to the receiver, and as the

 

acknowledgement messages are returned. Setting this value larger will cause a small reduction in

 

throughput. Setting this value too small will cause communications problems over longer distances.

 

Default distance is 20km

Save Changes

Save changes to non-volatile memory. Changes will not take effect until module is reset.

Save Changes and Reset

Save changes to non-volatile memory and reset module

Channel Selection

BU-945U-E (900MHz 802.11) channel selection is done by selecting the appropriate channel from the drop down list. Only channels available for that region will be available.

Channel (AP Only)

Channel (AP Only)

Australia

USA / Canada

3.8 DHCP Client Configuration

DHCP (Dynamic Host Configuration Protocol) allows DHCP Clients to automatically obtain their IP Address at start-up. This simplifies network administration, as there is no need to manually configure each device with a separate IP Address. The BU-945U-E is able to act as a DHCP client. To set the BU-945U-E to acquire its IP address from a DHCP Server, check the box “Obtain IP Address Automatically” on the Network Configuration page.

When configured as a DHCP Client the “Device Name” on the Module Information page will be the module identifier (as the IP address will be unknown) and so should be given a unique name.

30

www.cooperbussmann.com/BussmannWirelessResources

3A1582Rev1.6

Page 30
Image 30
Cooper Bussmann BU-945U-E 802.11 DSSS Dhcp Client Configuration, Channel Selection, Max Distance, Default distance is 20km