Siemens 620 appendix Installation and Removal of the Drive Holder

SIMATIC Box PC 620 Expansions

4.5Removal and Installation of Drives

4.5.1Removal and Installation of the Hard Disk Drive

1.Undo the 4 screws on the back of the housing.

2.Open the drive holder.

3.Detach the drive holder from the mounting and lay the drive holder with its top on the housing.

4.Note the cable assignment and pull off the cables.

5.Undo the four screws which secure the hard disk drive to the vibration-damped part of the mounting. Remove the hard disk drive from the mounting.

6.Proceed in the reverse order to fit the new drive. The new drive must be of the same type as the one removed.

Fixing screws

Figure 4-12 Installation and Removal of the Drive Holder

SIMATIC Box PC 620 Manual	4-17
A5E00131465-01