SIMATIC Box PC 620 Expansions

4.9Removal and Installation of the Device Fan

The Box PC is cooled by means of a fan which sucks hot air out of the housing.

1.Open the housing as described in Section 4.1.

2.Pull off the fan cable connector on the basic board.

3.The fan is secured to the housing by two plastic rivets. Undo the rivets by pressing out the gudgeon from the rear of the rivet shank.

4.Remove the fan.

5.Proceed in the reverse order for assembly.

Plastic rivets

Device fan

Figure 4-20 Removal and Installation of the Device Fan

Notice

Only a fan of the same type may be fitted!

Caution

! To ensure that the device is adequately cooled, take care that the running direction of the fan is correct when installing.

Ensure that the arrow on the fan points to the housing wall.

SIMATIC Box PC 620 Manual

4-25

A5E00131465-01

Page 85
Image 85
Siemens 620 appendix Removal and Installation of the Device Fan