Bosch Power Tools 1619EVS Dust Collection While Edge Forming, Attaching Dust Extraction Hood

BM2610995777 10/03 10/7/03 4:51 PM Page 14

	DUST COLLECTION WHILE		FIG. 15
	EDGE FORMING
The RA1170 dust extraction hood (optional
accessory) is used for dust collection when
edge-forming (Fig. 15).
!	WARNING	Read and understand
		these instructions and tool
manual for use of these accessories.
Do not reach in area of the bit while the
router is ON or plugged in.
!	CAUTION	To avoid entangling hoses,	ROUTER
		do not use this dust	SUB-BASE
extraction hood at the same time as any
other dust extraction hood.
ATTACHING DUST EXTRACTION HOOD			WORKPIECE
You can attach the hood in several places
according to your needs or preferences. This			EDGE
hood is attached using two of the screw			DUST
holes on the router base that are used to
			EXTRACTION
attach the router’s sub-base. Choose the
			HOOD
desired location for the hood. Loosen and
take out the two screws from the router base
and attach the dust extraction hood — over			The dust extraction hood itself is sized to
the router’s sub-base — using the screws			accept 35mm vacuum hoses. Also included
provided with the hood. Securely tighten the			is the VAC002 adapter that will connect the
screws (Fig. 16).			hood to 1-1/4’’ and 1-1/2’’ vacuum hoses.

	M4 x 16mm
FIG. 16
	SCREW

DUST

EXTRACTION

HOOD

SUB-BASE

M4 x 16mm

SCREW

-14-