8 en Configuration through the Web InterfaceDSDA iSCSI Disk Array Series

5Configuration through the Web Interface

NOTICE!

i

Do not use the S5B50 management software StoreVault Manager for the configuration. The

 

 

DSA series come with a dedicated Bosch standardized system layout. StoreVault Manager is

 

not compatible with the Bosch layout.

 

 

Follow these steps to configure each system. This procedure is nearly identical for all three types of storage systems.

1.Turn on the system.

DSA-S5B50: The power button is located on the front side on the left-hand side.

DSA-N2B20 /DSA- N2B50 / additional disk shelves: There is a power switch on each power supply unit (right- and left-hand side) on the rear side of the device.

If there are additional disk shelves installed, first power on the base unit, then power on the expansion units.

i

NOTICE!

It can take a few seconds until the LEDs on your system power supplies light up.

 

NOTICE!

i The Java Runtime Environment must be installed on your computer in order to use the Web interface. Always use the most recent version.

5.1

Configuration of the Network Settings and Access to the

 

Interface

All systems are delivered with a default IP address configuration of 10.10.10.10, netmask

255.0.0.0.In order to connect to the system, you need to configure a network interface on your computer to use the same network.

V 1 2008.08

Installation Guide

Bosch Security Systems