34 Setup
Emulation: Select the “personality” of the terminal. See the Quick menu earlier in this chapter.
Enhanced: Choose whether the terminal can respond to commands beyond the limitations of the current emulation. See the Quick menu earlier in this chapter.
Auto Wrap: [On, Off]
Select whether the cursor drops to the next line when it reaches the right margin or continues to display characters at the right margin. In ANSI emulations, the default is
off.
Auto Font Load: [On, Off]
Select whether the four font banks
Auto Page: [On, Off]
When the cursor is moved off the page using a command that includes scroll and Auto Page mode is on, the screen displays the new page. These pages are numbered from 0 to a maximum of 9. When on, Auto Page will track the page even if Auto Scroll is off. The
Auto Scroll: [On, Off]
Choose whether the terminal updates the display when the cursor is moved beyond the boundaries of the currently viewed screen.
Monitor Mode: [On, Off]
Choose whether control codes will be displayed as their graphic representations or be acted upon as terminal/cursor commands.
Screen Saver: [Off, 2 min, 5 min, 15 min, 30 min]
Select whether the screen will go blank after lack of activity from the keyboard or the host of the selected period of time. The first key typed at the keyboard when the screen is blank will reactivate the display. The keycode will not be transmitted to the host. The Caps Lock LED (or Lock on the ANSI keyboard) will flash while Screen Saver is active.
Use screen saver to prevent “phosphor burn” on the screen when the display on the terminal is left unchanged for an extended time period.
20 minutes after the screen saver is activated, Energy Star, a power saving feature, is activated. The first key typed at the keyboard brings the energy level back up.
Bell Volume: [0, 1, 2, 3, 4, 5, 6, 7, 8, 9]
Select the bell volume from off [0] to high [9]. This will be the volume for alarm tones, warning bells, and keyclicks.
Warning Bell: [On, Off]
Select whether a warning bell is sounded when errors (such as an invalid compose sequence) are encountered.
Sessions: [One, Two]
Select the number of sessions (hosts) that the terminal will run. See the Quick menu earlier in this chapter.
Session Display: [Full, Split]
When two sessions are used, select whether each host’s data displays on a full screen or if both hosts share a split screen. In either case, the way to toggle between the hosts is by using