28 Setup
Saving Parameters
Upon exiting setup mode, the prompt “Save All (Y/N)” blinks. Press Y or y to exit setup and save settings in permanent (nonvolatile) RAM. Press C or c to cancel the exit request. Press
N or n to exit Setup. The changes will take effect, but will be lost if the terminal is reset or powered off.
An exception to this is function/edit key and answerback message programming. Once edited in Setup, the changes are saved regardless of the way in which you exit Setup.
Movement Inside Menus
F1 through F12: Select the menu that corresponds to the function key. Access to the “EXEC” menu is available using either the Print
Cursor Control Keys (− ← ↓ →): These keys control movement to parameters within the menu and is indicated by a highlighted selection bar. This selection bar will wrap to the other side of the menu at the top, bottom and side boundaries. For each parameter there are at least two choices. As the parameter is highlighted, the available choices appear in the area above the help bar.
Some parameters are action fields and have no choices. See the Action Fields section later in this chapter.
Enter and
