Installing the Setback Control

Removal of Setback Control Protective Plate

Step 3: Remove the Setback Control Protective Plate from the Setback Control by pulling these components in opposite directions, as shown in Figure 3. Retain the protective plate if the Setback Control will be remote mounted.

Setback Control

Setback Control

Protective Plate

Figure 3

Install Batteries

Step 4: Remove the battery holder from the Setback Control, and install (2) AAA batteries. Replace the battery holder after the batteries are installed. This is shown in Figure 4.

Battery Holder

Figure 4

-7-

Page 7
Image 7
Bradford-White Corp 47808A, 238-47808-00A operation manual Removal of Setback Control Protective Plate, Install Batteries