Setting a Temporary Temperature Hold
If an alternate water temperature is required for a short period of time, follow the instructions in this section to temporarily modify the Setback set water temperature.
Setting a New Water Temperature
Step 1: From the Home screen, press the UP (increase water temperature) or DOWN (decrease water temperature buttons until the new desired water temperature is shown. This is shown in Figure 103.
Temperature digits are flashing
Figure 103
Display of Temporary Hold Water Temperature
Step 2: A temporary hold will maintain the water heater setpoint at the new setting for two hours. Then, the Setback Control will revert back to its programmed schedule. When the Setback Control is in a temporary hold, the “Hold,” in the lower left corner of the display, will be flashing. This is shown in Figure 104.
"Hold" flashes for a Temporary Hold
Figure 104
Exiting a Temporary Hold
Step 3: To manually exit a Temporary Hold, press the RIGHT (Schedule) button, as shown in Figure 105.
Figure 105
