Pre-Lift Operation Notes and Details
Lift Features (continued)
Before pressing the orange FOLD (In) switch to fold the platform to the stowed position, the lift operator must press the red UP switch to be certain the platform is in the fully raised position. The platform must be in the fully raised position before the platform can be
back and the bridge plate flap. The independent hinged bridge plate flap bridges the gap between the lift platform and the vehicle floor when the platform is positioned at floor level, providing a surface for wheel- chair (or standee) travel.
The bridge plate unfolds (ro- tates) from the stowed position
L200UARS Series lifts unfold and fold at a position above floor level (fully raised). The lift attendant (operator) must position (lower or raise), and stop the platform at vehicle floor level when a passenger is entering or exiting the vehicle. The platform must be properly positioned at a height such that
folded.
The lift operator should continue to press the orange FOLD (In) switch until the actuator ratchets (makes audible clicking) when folding the platform to the stowed position to ensure the lift is fully stowed.
Bridge Plate: The bridge plate assembly consists of the striker
to the bridging (horizontal) | Striker Back | Bridge Plate Flap | |
position as the lift platform |
|
|
|
|
|
| |
unfolds and vice versa. The |
|
|
|
bridge plate flap rests on the |
|
|
|
platform when deployed |
|
|
|
(unfolded). Read warning |
|
|
|
posted on opposite page. |
|
|
|
Discontinue lift operation |
|
|
|
immediately if the bridge |
|
|
|
plate does not operate |
|
|
|
properly. |
|
|
|
|
|
|
|
Page 16
