CARE AND CLEANING
Before cleaning, ensure the ‘Selector Control’ is in the ‘STANDBY’ position and press the ‘POWER’ button ‘Off’, then unplug the power cord and allow the unit to cool.
Cleaning The Steam Wand And Froth Enhancer
•The steam wand and froth enhancer should always be cleaned after frothing milk.
•If attached, remove the froth enhancer and rinse under warm tap water.
•Soak the tip in hot water before using the pin on the cleaning tool to unblock. Replace the tip back onto the steam wand and secure with the cleaning tool.
•Wipe the steam wand with a damp cloth, and then with the steam wand directed back into the drip tray, briefly set the ‘SELECTOR CONTROL’ to the ‘STEAM’ position. This will clear any remaining milk from inside the steam wand.
•If the steam wand becomes blocked, wait for the machine to cool before using the ‘CLEANING TOOL’ to unblock the opening.
NOTE:
The 'Cleaning Tool' is located at the front of the machine under the left of the group head.
•If the steam wand continues to be blocked, the tip of the steam wand can be removed by using the spanner in the middle of the cleaning tool.
Cleaning The Filters, Filter Holder And Brewing Head
•The stainless steel filters and filter holder should be rinsed under water directly after use to remove all coffee particles. Should the fine holes in the filters become blocked; the fine pin on the cleaning tol can be used to clear the holes.
•The group head interior should be wiped with a damp cloth to remove any ground coffee particles.
•Periodically run water through the machine with the filter holder in place, but without any ground coffee, to rinse out any residual coffee particles.
17
