Briggs & Stratton 100, 200 Remote Module LED Status Indicators, Low Voltage (Single and Dual) Models

Remote Module LED Status Indicators

Symphony II System does not communicate or manage appliances/loads when utility power is present.

NOTICE When looking at LED’s, make sure you look straight on and not at an angle.

Low Voltage (Single and Dual) Models

A

C

B

ED

LED is for signal communication status (C).

Utility power present:

•Normal State

-Orange LED - No communication and appliances/ loads cannot be managed by Symphony II System

•Problem State (see Troubleshooting)

-No LED - No power to low voltage control board; verify correct wiring

-Green LED - Broken LED; replace low voltage module

-Red LED - Fault in system; verify current transformer connections, verify terminations on orange and yellow communication wires

Generator power present:

•Normal State

-Green LED - Signal communication detected and appliances/loads can be managed after

5 minute delay

•Problem State (see Troubleshooting)

			- No LED - No power to low voltage control board;
		REPRODUCTION
			verify correct wiring
			- Orange LED - Signal communication not detected;
A - Low Voltage Control Wiring Terminal Contacts			verify correct wiring
B - Priority Selector			- Red LED - Fault in system; verify current
			transformer connections, verify terminations on
C - Communication LED			orange and yellow communication wires
D - Neutral Connection	NOT
E - Power/Line Connection
	FOR

18 BRIGGSandSTRATTON.COM