Briggs & Stratton 30473 31

2.Disassemble panel cover to locate and check the wire connections (A, Figure 66).

3.Locate battery winding connector (B, Figure 67) and mesure resistance across the terminals (C).

Figure 66

•Repair and/or replace any loose wire connections and retest.

•If DC ouput is still not measured, proceed to Step 3.

Not

for

ReproductionFigure 67

• If resistance is 0.3 - 0.7 Ω the winding is good.

• If resistance is not to specification, check wire connections, r repair/repace wires, then retest.

• If resistance is still not to specification, replace battery winding.

Contents

POWERSMART SERIES™ INVERTER GENERATOR SERVICE AND REPAIR MANUAL MODEL Page Important Safety Instructions Generator Components Maintenance Troubleshooting Generator Specifications Important Safety Instructions When Adding or Draining Fuel When Starting Equipment When Operating Equipment When Transporting, Moving, or Repairing Equipment When Storing Fuel or Equipment with Fuel in Tank Page Generator Location Fuel Recommendations Fuel Tank Cap Vent Lever Grounding Fastener Generator Components Maintenance Engine Maintenance Oil Changing Engine Oil Service Air Cleaner Service Spark Plug Inspect Muffler and Spark Arrester Adjust Valve Clearance NOTE: Clean and inspect the spark arrester as f ll ws: Rewind Starter Replacement Inspect Rewind Starter Parts Assemble Rewind Starter Troubleshooting Fuel System Fuel Valve Fuel Filter Carburetor Page Page Stepper Motor Page Engine Will Not Start Low Oil Switch Ignition Winding Test Ignition Trigger Coil Test Ignition Coil No AC Output No DC Output Page Generator Specifications Starting Wattage Wattage Load Current at 120 Volts AC Generator Wiring Diagram