Regular Maintenance
Seat Adjustment
The height of the seat (A, Figure 27) can be adjusted either up or down and the position of the seat can be adjusted forward or back to accomidate the operator’s comfort level.
1. Remove the seat height adjustment hardware (B).
A
2. Position the seat at the desired height and |
|
|
distance and reinstall and tighten the seat |
|
|
adjustment hardware. | B | B |
| ||
|
|
Figure 27. Seat Height Adjustment
A. Seat
B. Seat Height Adjustment Hardware
Neutral Adjustment |
|
| |||
If the unit “creeps” while the ground speed control |
| ||||
|
|
| Reproduction | ||
levers are in the NEUTRAL position, then it may be | for | ||||
necessary to adjust the linkage adjuster rods. |
| ||||
1. | Park the machine on a flat, level surface such as |
| |||
| a concrete floor. Disengage the PTO, engage the |
| |||
| parking brake and turn off the engine. |
| |||
|
| CAUTION |
|
| |
This adjustment should not be performed while |
| ||||
the machine is running. |
|
| |||
2. | Loosen the jam nut (A, Figure 28). |
| |||
3. | Turn the linkage rod adjuster (B) toNotadjust the |
| |||
| neutral of the machine: |
|
| ||
| • | If the machine creeps forward, turn the linkage |
| ||
|
| rod adjuster CLOCKWISE. |
| C | |
| • | If the machine creeps backwards, turn the | |||
|
| ||||
|
| linkage rod adjuster | B | ||
|
|
|
| ||
4. | Retighten the jam nut when adjustment is | A | |||
| complete. |
| |||
|
|
| |||
5. | Start the engine. |
|
| ||
6. | Disengage the parking brake and make sure all |
| |||
| controls are in the NEUTRAL position. | Figure 28. Neutral Adjustment | |||
7. | If the machine still “creeps” repeat the NEUTRAL | ||||
A. Jam Nut | |||||
| ADJUSTMENT procedure. It may take several | ||||
| B. Linkage Rod Adjuster | ||||
| attempts to achieve neutral depending on how | ||||
| C. Control Ramp Rod | ||||
| much the machine creeps. |
|
|
28 | www.ferrisindustries.com |