Briggs & Stratton S175X Fuel Filter, Service Air Filter, Reproduction, To Replace the Fuel Filter:, To Drain the Water Separator:

To Drain the Water Separator:

Regular Maintenance
Fuel Filter
This unit is equipped with two fuel filters. One is
a water seperator (A, Figure 19) and the other is a
fuel filter (C). Both filters are located in the engine
compartment on the right side of the engine. The
water separator should be drained every 25 hours
or whenever water is visible in the bowl. Replace	A
both fuel filters every 500 hours of operation or as
required.
To Replace the Fuel Filter:
NOTE: Fuel filter is replaced as an assembly only.	B
The filter element is not replaceable separately.

1.	Turn the engine off, set the parking brake, remove
	the ignition key, and wait for all moving parts to
	stop.
2.	Allow the engine and surrounding areas to cool to
	room temperature.
3.	Close both fuel tank shut off valves (See Figure 2					C
	for location).
		Reproduction
4.	Open the hood to gain access to the fuel			for
	filter. The fuel filter is located in the engine
	compartment on the right side of the engine.				Figure 19. Replac ng the Fuel Filter
5.	Place an absorbant cloth below the filter to catch				A. Water Sepera r
	any spilled fuel.		Not		B. Fuel Pump
6.	Loosen the hose clamps that secure the h ses				C. Fuel Fil er
	the fuel filter.
7.	Remove the hoses from the filter.
8.	Install the new filter in the proper flow direction in
	the fuel line.
9.	Secure with the hose clamps and wipe up any
	spilled fuel.

10. Reopen the fuel tank shut off valves wh n complete.

Refer to engine owners manual for specific water seperator service procedures.

Service Air Filter

Refer to the engine owner’s manual for specific air filter service procedures.

30 www.SnapperPro.com