Regular Maintenance
CAUTION
A
Avoid injury. Mower blades are sharp.
• Always wear gloves when handling mower blades or working near blades.
•Always wear safety eye protection when grindingB
1. | Sharpen the mower blade with a grinder, hand file, |
|
| |
Figure 36. Sharpening the Mower Blade | ||||
| or electric blade sharpening. | |||
| A. Mower Blade Bevel | |||
2. | Sharpen the mower blade by removing an equal | |||
B. Mower Blade Cutting Edge | ||||
| amount of material from each end of the mower | |||
|
|
| ||
| blade. |
|
| |
|
|
| ||
3. | Keep the original bevel (A, Figure 36) when |
|
| |
| grinding. Do NOT change the mower blade bevel. |
|
| |
4. | The mower blade should have a maximum 1/64” |
|
| |
|
| |||
| (0,40 mm) cutting edge (B) or less. |
|
| |
5. | Balance the mower blade before installing. |
|
|
Balancing the Mower Blades | Reproduction |
| ||
|
| |||
CAUTION |
| orf | A | |
|
|
| ||
|
|
|
| |
Avoid injury. Keep mower blades balanced. |
|
|
| |
• An unbalanced mower blade can create |
|
|
| |
excessive vibration and damage the unit or |
|
|
| |
cause mower blade failure. | Not |
| Fig re 37. Balancing the Mower Blade |
|
|
|
| ||
|
|
|
| |
1. Clean the mower blade to remove any dried grass | A. Nail |
| ||
or other debris. |
|
|
|
|
2. See Figure 37. Put the mower blade on a nail in a |
|
| ||
vise and turn the blade to the horizontal position. |
|
| ||
3. Check the balance of the mower blade. If either |
|
| ||
end of the mower blade moves downward, |
|
|
| |
sharpen the heavy end until the mow r blade is |
|
| B | |
balanced. See SHARPENING THE MOWER |
|
| ||
|
|
| ||
BLADES for proper sharpening instructions. |
|
|
| |
4. Repeat the process until the mower blade remains |
|
| ||
in the horizontal position. |
|
|
|
|
Reinstalling the Mower Blades |
|
|
| A |
1. Reinstall each mower blade with the air lifts |
|
| ||
| D |
| ||
pointing up towards the mower deck as shown in |
| |||
|
| |||
Figure 38. Secure with the mower blade mounting |
|
| ||
bolt and flat washer (A & B, Figure 38) and torque |
|
| ||
to 70 ft. lbs (94 Nm). |
|
|
|
|
2.Wedge a wooden block between the mower blade and the mower deck housing to keep the mower
blade from turning. | Figure 38. Tightening the Mower Blade for |
| Installation |
| A. Mower Blade Mounting Bolt |
| B. Flat Washer |
| C. Mower Blade Air Lift (Points Up For Installation) |
| D. 4 X 4 Wooden Block |
37