Patio Base Installation
5.For Grill Heads other than R3 Series, continue on to Step 6. For R3 Series Grill Heads: Bend the tabs on the Post Cover Plate to 90° as shown in Figure 5. Two different size cover plates are included with the R3 Series Grill Heads. Choose the plate that will best fit your post.
Note: If using the stainless steel Post Cover Plate, bend the tabs so they face away from the protective film. Remove the protective film after bending the tabs.
7.Position the grill head onto the post and fasten with
PROTECTIVE
FILM SIDE
COVER PLATE
Figure 5
6.For R3 Series Grill Heads: Slide the Post Cover Plate onto the front of the post. Slide the Upper Bracket onto the post. Secure the Post Cover Plate and Upper Bracket to the top of the square post using four #10 – ½ Self Drill screws for stainless steel posts and 10 x 1/2 Hex Head screws for black posts. See Figures 5 and 6.
For Grill Heads other than R3 Series: Slide the Upper Bracket into the post. Secure the Upper bracket to the top of the square post using four #10 – ½ Self Drill screws. See Figure 6.
Figure 6
Figure 7
8.Arrange with your local gas company or licensed contractor to have a gas supply line connected to the inlet of the stainless steel flex tube assembly. The gas supply must have a shutoff valve that is close to the post in case of emergency and must be shutoff when the grill is not in use.
Installing old grill head P3 or P4 to new patio post.
A B101668 kit will need to be used to cover the opening in the post. See the instructions with the kit for further installation information.
Figure 8
Page 15 |
